Onslaught® Powershot Wasp & Hornet Aerosol

MGK · MGK 264 0.08%; Piperonyl butoxide 0.05%; Pyrethrins 0.025%; Esfenvalerate 0.05% · EPA Reg 1021-1852 · INSECTICIDE Document last checked 2024-05-21

← Back to Onslaught® Powershot Wasp & Hornet Aerosol product overview

According to the label From the product label

These details were extracted from this product's label PDF. The label is the law. Confirm every rate, site, restriction and safety requirement against the label before mixing or applying. Check for a state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below. · EPA registration data for Reg. 1021-1852 →

This aerosol product is designed to control wasps, yellowjackets, mud daubers, hornets, spiders (including black widows), scorpions, crickets, ants (excluding carpenter, fire, and harvester ants), centipedes, and earwigs. For nests, spray the area until soaked at sunrise or sunset while standing a safe distance away. It can also be used for spot treatments on outdoor building surfaces and perimeters, such as the sides of buildings, eaves, soffits, doors, windows, and potential entry points. For individual insects, apply in 1 to 2 second bursts directly on the target.

Pests covered (18)

Wasps, Yellowjackets, Mud Daubers and HornetsSpiders (including Black Widows), Scorpions, Crickets, Ants (excluding carpenter ants, fire ants and harvester ants), Centipedes and EarwigsinsectsCENTIPEDESSCORPIONSSPIDERSBLACK WIDOW SPIDERTICKSEARWIGSWASPSANTSCARPENTER ANTSMUD DAUBERSHORNETSYELLOWJACKETSBITING INSECTSCRICKETSCRAWLING INSECTS

Areas treatable (3)

nestsbuilding surfaces and perimeters (spot treatments) on structures onlyDOMESTIC DWELLINGS (OUTDOOR)

How to treat each type of area 3

nests

Spray at sunrise or sunset [dusk] when insects are least active. Stand a safe distance from the nest. Do not stand directly underneath or above nest. Shake can well before each use. Always hold can upright while spraying. With wind at your back, aim nozzle at nest and spray until soaked. Wait 24 hours before removing the nest.

Target pest: Wasps, Yellowjackets, Mud Daubers and Hornets
Location: Outdoor

Target pest	Rate	Unit	Label notes
Spiders (including Black Widows), Scorpions, Crickets, Ants (excluding carpenter ants, fire ants and harvester ants), Centipedes and Earwigs	1 to 2 second bursts	seconds	Spray 1 to 2 second bursts directly on insects. For scorpions, stand 3 to 4 feet away and thoroughly cover the insect. Make sure scorpions are dead before removing.

building surfaces and perimeters (spot treatments) on structures only

Limited outdoor residential application to building surfaces and perimeters (spot treatments) on structures only. (1) Applications to the side of a building, up to a maximum of 3 feet above grade; (2) Applications to underside of eaves, soffits, doors, or windows permanently protected from rainfall by a covering, overhang, awning, or other structure; and (3) Applications around potential pest entry points into buildings, when limited to a surface band not to exceed one inch in width.

Target pest: insects
Location: Outdoor

Worker safety

PPE required Avoid contact with skin, eyes, or clothing. Wash hands thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco or using the toilet. Remove and wash contaminated clothing before reuse.

Timing & weather

Do not make applications during rain.
Spray at sunrise or sunset [dusk] when insects are least active.
Applying this product in calm weather when rain is not predicted for the next 24 hours will help to ensure that wind or rain does not blow or wash pesticide off the treatment area.

Use restrictions 9

THIS PRODUCT IS FOR LIMITED OUTDOOR RESIDENTIAL APPLICATION TO BUILDING SURFACES AND PERIMETERS (SPOT TREATMENTS) ON STRUCTURES ONLY.
Application of this product is prohibited directly into sewers or drains, or to any area like a gutter where drainage to storm sewers, storm drains, water bodies, or aquatic habitat can occur.
Do not allow this product to enter any drain during or after application.
Do not contaminate food or feedstuffs.
Avoid spraying plants. Rinse any foliage with water that is contacted by this product.
Do not use this product around electrical equipment or outlets because of possible shock hazard.
Do not apply this product in a way that will contact adults, children, or pets, either directly or through drift.
Do not apply this product or allow it to drift to blooming crops or weeds while bees are actively visiting the area.
Do not use or store near heat or open flame. Do not puncture or incinerate container. Exposure to temperatures above 130°F may cause bursting.

Label SDS

Catalog source document available. The local copy is still withheld until its exact product identity, role, and full file hash are accepted. Open the catalog source label ↗ and verify the product name, EPA registration number, and revision before relying on it.

Publication withheld. This catalog record has no active evidence summary, so its document and any extracted directions remain unavailable while identity and document role are reviewed.

Document text and citations

Extracted text is retained internally for document review and page-level citation checks. The complete third-party text is not republished here; use the document viewer above.

Reference only. Always read and follow the most current EPA-approved label on the product container. State and local restrictions may apply that are not reflected in this digitised copy. Verify the EPA registration number and revision date before use.